Tempered Glass Installation
Watch the video and follow the steps below for a bubble-free finish.
Step-by-Step Guide
1. Clean Screen
Use the wet wipe first, then the dry wipe to remove all oil.
2. Remove Dust
Use the dust-absorber sticker to pick up tiny dust particles.
3. Peel Backing
Peel off the back layer. Do not touch the sticky side.
4. Align Glass
Align with the speaker or camera hole and gently lower it.
5. Press Center
Tap the center of the glass to let the adhesive spread.
6. Push Bubbles
Push any remaining bubbles towards the nearest edge.Pro Tips
- Turn off the Fan/AC to reduce flying dust.
- Wait 30 minutes before putting your phone back case on.
- Premium Japanese adhesive allows you to safely lift and reapply if bubbles occur.
🔒 In-Display Fingerprint Tip (Crucial Step!)
Notice your fingerprint scanner acting a little slow after installation? Don't worry, your new glass isn't defective!
Because our tempered glass adds a tough, shatter-resistant layer over your screen, your phone's sensor simply needs to "re-learn" your print through the new protection.
Quick Fix for Lightning-Fast Unlocks:
- Go to your phone's Settings > Security.
- Delete your old fingerprints.
- Re-add your fingerprints after the glass is fully installed.
💡 Pro Tip: Register your primary thumb twice as two separate fingerprints. Your phone will unlock instantly every single time!
Need More Help?
If you are unable to apply the glass or facing any issues, please contact our support team.
support@shinroe.com